Advantages of Switching to Waterjet Cutting Technology
As technology take a peak, cutting technology has not been left behind. Waterjet cutting technology uses water pressure to cut material. Although not many people are familiar with this cutting technology, it way far much better cutting method compared to other cutting methods. Below are some of the reasons why you should consider switching to waterjet cutting technology.
Waterjet technology does not damage the materials as it passes through them. The end product of the materials being cut is therefore not damaged and is in good condition. The waterjet does not produce any heat while cutting and therefore there is no warping, hardening or other effects of heat in the material being cut. The only way to protect the material that you are cutting from all heat associated problems is by use of waterjet cutting technology.
The other point that should make you switch to waterjet cutting technology is because it has accurate precision. It is easier for you to control the shapes and sizes of the material that you are cutting as this technology allows accurate precision. Due to the technology’s ability to have accurate precision, it does not require you to have an extra machine for clear cuts, only some sanding. It is, therefore, right to say that this technology will save you on your costs.
The third reason why you should switch to waterjet cutting technology is because this technology allows cutting of almost all the materials. By use of water pressure that is created by this waterjet cutting technology, it is possible to cut through coarse metals, thick plastics, glass, and other materials. Adding abrasives to the water allow the machine to cut more pieces than without the abrasives. If you want to cut many pieces of different materials, then you know what to go for, waterjet cutting technology.
The other reason why you should consider switching to waterjet cutting technology is that the machine produces minimal gases and dust. Many of the gases that ate produced during the process of cutting are not healthy to inhale and can cause health problems to those who inhale them. The life of the worker is not put at risk when you are using a waterjet cutting machine because the machine produces very minimal dust and gases compared to other cutting methods. Choose a method of cutting that is the most suitable the will not put your life at risk, also avoid using abrasives in this waterjet cutting machine as it may result in more dust and gases. The above are some of the very good reasons why you should switch to waterjet cutting technology.